FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.
FOAM-CURE™ works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE™ does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE™ requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate.
* SURFACE SHIPPING
ONLY (US Customers) - This item can only be shipped via surface/ground
shipping. Purchasing this item will result in your entire order being
only eligible for either UPS Ground or USPS Parcel Post shipping. US
customers located outside the contiguous lower 48 states (such as Hawaii
or Alaska) can contact us to determine a shipping cost if the webstore
is not be able to determine the shipping cost.
* NO INTERNATIONAL SALE - This item cannot be shipped outside the United States.